Casting Machine for Titanium TITEC F205M

The casting machine TITEC® by OROTIG works completely automatically, controlling the fundamental parameters that are required for a perfect cast. The internal logic determines: the regulation of the vacuum, the saturation level and the over-pressure of the argon, the period over which the current is supplied to the arc, and the moment at which the chamber is inverted. The melted metal is only poured into the mould if all the conditions are perfect: this way one creates the necessary basis for obtaining constant results.


Fonditrice Automatica Monocamera per Titanio Titec F205M


From the evolution of the previous two-chamber model, in which melting and casting occurred in separate chambers, an innovation in melting and casting of titanium was born. The single-chamber system (patented by OROTIG) permits to optimize the characteristics of melting under pressure for casting titanium.

This new single chamber configuration allows to melt the titanium in close vicinity of the casting cylinder, which results in very short transfer times of the melted titanium from the copper crucible to the mould. The mass of liquid metal is kept hotter and more compact this way, and it allows for much faster casting times. These characteristics lead to a very accurate reproduction of the details of the model and it simplifies the techniques that are used by the technician.

With the same single chamber configuration it is possible to cast chrome-cobalt as well, by substituting only the crucible.

Main advantages:

  • The melted titanium is very close to the inlet of the casting cylinder
  • The transfer time of the melted titanium from the crucible to the casting cylinder is very short, which keeps the mass of titanium nicely compact
  • The titanium looses less heat and is injected into the casting cylinder at a higher temperature
  • Double pressure valve for an injection of titanium which is almost instantaneous
  • Very accurate reproduction of the edges of the model
  • Simple operation of loading and positioning of the casting cylinder inside the casting machine
  • Double check of the vacuum level by the use of an analog device for low vacuum levels and a Pirani probe for verifying the high vacuum
  • Casting cycle which is completely automatic
  • Simpler laboratory technique

Principle of operation:

Here you can download the movie of the melting Titanium(Italian speaking only).

Filmato Fonditrice, Presentazione macchina e dimostrazione di una fusione
(durata approx 4 minuti con un modem a 56K), necessita Windows Media Player 7 o superiore.

Specification:

Monofase

Trifase
Type of power for melting the metal Inverter Arco a corrente costante
Supply Voltage (VAC) 230V 400V
Type of power connection (Number  of phases) 1 3
Frequency (Hz) 50 - 60 - 50/60
Power absorbed when melting (KVA) 7,5
Voltage at the command buttone (V) < 24 AC/DC
Type of melting process TIG/WIG
Work Cycle (%) 100
Absorbed power (not when melting) (VA) 105
Maximun quantity of metal can be melt (gr) 40
Maximun diameter of casting ring that can be used (mm) 85
Working temperature (°C) 10 - 40
Minimun pressure of the shield gas (BAR) 3,5
Gas consumption for metal/casting cycle (Liter) 6 with 3,5 bar
Type of cooling Natual convection
Approximate dimensions (HxWxD) 76 x 51 x 61
Empty weight (Kg) 120
Maximum humidity of environment (%) 65
Noise levek (dB(A)) <70
Required purity as GARANTEE and CERTIFIED of the Argon shield gas (%) 99,996
Grade of pure Titanium FOR DENTAL USE, according standard ASTM-67 1 al 4
RECOMMENDED for fixed prosthesis and implant-supported structures Grado 2
RECOMMENDED for frameworks and partial dentures Grado 4

For further informations, prices or estimates please contact us at address:

© 2007 - OROTIG Srl.

[top]